Hardware options installation
• The NS204i-u Gen11 NVMe Hot Plug Boot Optimized Storage Device is a PCIe3 x4 custom form-
factor module that includes two hot pluggable 2280 M.2 NVMe SSDs.
• NS204i-u Boot Device auto-creates a RAID1 volume during boot, therefore does not require
configuration.
• Identify the NS204i Boot Device components.
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack.
• Remove the server from the rack.
4. Remove the access panel.
5. Install the drives to the boot device.
6. Install the boot device to the mounting bracket.
7. To allow drive access, remove the security cover.
If you want to secure drive access, keep the security cover installed.
To Next Page
Loading...
