Hitachi RCI-4.0FSR - Removal Of The Automatic Louver Motor

7 Servicing
RCIM-(0.4-2.5)FSRE - 4-way cassette (compact)
SMGB0137 rev.0 - 05/2021
200
7.2.13 Removal of the automatic louver motor
1 Stop the automatic louver:
a. Press AUTO LOUVER on the remote control while the automatic louver is operating.
b. The crank touches the end of the motor securing plate and the louver returns to position 0.
c. The motor power supply switches o󰀨 when the louver is at the set position.
d. The louver stops at the set position.
2 Remove the optional air panel in line with the instructions given in chapter “7.2.4 Removal of the optional air panel”.
3 Remove the xing screw for C-cover and remove the C-cover.
4 Remove the xing screw on the AS motor from the air panel. Then, remove the louver, the louver bearing and the AS
motor.
5 Remove the AS motor, stopper and bearing from the louver.
6 Disconnect the connector for the AS motor. Press the catch to disconnect the connector to avoid breakage.
Screw
Air panel
C-Cover
Louver
Bearing
AS Motor
Connector
Air panel
Bearing
Bearing
Bearing
Louver
AS Motor
Stopper
Stopper
Air inlet side
Pay attention to the
direction of the stopper.