7 Servicing
RPI(L/H)-(0.4-6.0)FSRE - Ducted indoor unit
SMGB0137 rev.0 - 05/2021
222
4 Carefully separate the electrical box from the indoor unit and softly pull the electrical hose out of the box.
7.5.2 Mount the electrical box on the right side
a. Loosen and remove the 3 screws holding the lower panel.
b. Remove the bottom panel and leave it somewhere that it will not be disturbed.
c. Re-route the electrical hose to the inside of the indoor unit and secure it with the pre-assembled anges.
d. Mount the electrical box in its new location (right side) and fasten it with the 2 xing screws.
e. Make sure that the entire electrical hose is properly secured and exits through the right-hand side wall opening.
! CAUTION
The electrical hose must not be tightened or forced at any point in its route.
f. Mount the lower panel of the indoor unit and secure it with the 3 xing screws.
To Next Page
Loading...