Hitachi RCI-4.0FSR - RPI-(8.0-20.0)FSN3(P)E(-F) - Ducted Indoor Unit; Removal Of The Electrical Box Cover; Removal Of Electrical Components

7 Servicing
RPI-(8.0-20.0)FSN3(P)E(-f) - Ducted indoor unit
SMGB0137 rev.0 - 05/2021
235
7
7.6 RPI-(8.0-20.0)FSN3(P)E(-f) - Ducted indoor unit
? NOTE
In the following general illustrations are examples for RPI-(8.0/10.0)FSN3E(-f), but they are applicable for RPI-(16.0/20.0)FSN3PE(-f) as
well. In the specic cases where there are dierences between both units, the illustrations are shown separately for each one.
7.6.1 Removal of the electrical box cover
1 Remove the set screws -A- from the electrical box cover to access the electrical components.
7.6.2 Removal of electrical components
1 Remove the electrical box cover as indicated in chapter
“7.6.1 Removal of the electrical box cover”.
2 Separate the connections of all electrical components.
3 Remove the set screws -A- and separate the full electrical
component support -B-.
! CAUTION
Handle the support carefully to avoid damaging the electrical components.