Hitachi RCI-4.0FSR - Remove The Switch Cover; Replacing Dip Switch Pcb (Pcb2)

7 Servicing
RPK-FSR(H)M - Wall mounted
SMGB0137 rev.0 - 05/2021
249
7
7.7.4 Remove the switch cover
Remove the at panel as indicated in section “7.7.2 Removal of the front panel”. The switch cover can be opened without
removing the front panel.
PCB2
Switch cover
7.7.5 Replacing DIP Switch PCB (PCB2)
a. Remove the at panel.
b. Remove one (1) screw xing the switch cover to remove it.
c. Disconnect the connectors for PCB2.
d. Remove spacers and then PCB2.
e. After the replacement, attach PCB2 in the reverse procedure.
f. Set the capacity code on DSW3.
Switch Cover
PCB2
Screw for
Switch Cover
Spacers
DSW5
RSW1
RSW2
DSW6
DSW9 DSW2
SW2
DSW3
DIP Switch PCB (PCB2)
Screw for
Switch Cover
Switch Cover
Spacers