Hitachi RCI-4.0FSR - DX-Interface Servicing

7 Servicing
RPF(I)-(1.0-2.5)FSN2E - Floor and Floor concealed type
SMGB0137 rev.0 - 05/2021
267
7
7.8 RPF(I)-(1.0-2.5)FSN2E - Floor and Floor concealed type
7.8.1 Removal of the air inlet grille
RPF-(1.0-2.5)FSN2E
1 Loosen the screws on the securing plate of the right part of the
grille then remove the plates.
2 Press the button on both sides of the grille in the direction
indicated by the arrow. The grille can be opened at a 30° angle.
3 Remove the air inlet grille from the hinges.
Knob
7.8.2 Removal of the air lter
RPF-(1.0-2.5)FSN2E
The air lter is located inside the air inlet grille.
1 Remove the air inlet grilles as indicated in section “7.8.1 Removal
of the air inlet grille”.
2 Remove the lter by pulling the lter button.
Air lter
7.8.3 Removal of the air outlet grille
RPF-(1.0-2.5)FSN2E
1 Remove the screw holding the securing plate.
2 Open the upper panel so that it is vertical.
3 Slide and remove the air outlet grille.
Top panel
Fixing plate
Discharge air
grille