Hitachi VSP F1500 - Page 337

Error
code
Error
message
Condition Recommended action
Returne
d Value
command. And also confirm the
command execution environment to be
set as HOMRCF.
EX_ENLD
EV
No such
LDEV
within the
RAID
A device defined in the
configuration definition file
does not have a mapping to
a real LUN and target ID
within the RAID storage
system.
Please confirm that the Port, Target ID,
LUN are defined correctly under
HORCM_DEV in the configuration
definition file.
227
EX_INVR
CD
Invalid
return
code
Wrong return code. Contact Hitachi Data Systems customer
support.
226
EX_VOLC
UR
S-VOL
currency
error
Currency check error for S-
VOL. Cannot guarantee
identical data on S-VOL.
Check the volume list to see if an
operation was directed to the wrong S-
VOL.
225
EX_VOLC
UE
Local
volume
currency
error
The volume specified with
the S-VOL-takeover
command is not the same as
the P-VOL.
Please confirm the pair status of the
local volume using the pairdisplay
command.
224
EX_VOLC
RE
Local and
remote
volume
currency
error
The combination of the
volumes specified with
Swap-takeover is unsuitable.
Please confirm the pair status of remote
and local volumes using the
pairdisplay command.
223
EX_UNW
ERR
Unknown
error
code.
Wrong error code. Contact Hitachi Data Systems customer
support.
--
EX_ENOC
TG
Not
enough
CT
groups in
RAID
The specified CTG ID cannot
be used when the volume for
TrueCopy, Universal
Replicator, global-active
device or ShadowImage pair
is created, because the
specified CTG ID is used by
the other program product in
the storage system.
Otherwise, CTG ID cannot be
registered because the
number of the consistency
groups exceeds the
maximum number.
For details about the
maximum number of the
consistency groups, see
TrueCopy Async, TrueCopy,
Universal Replicator, and
global-active device volumes
on page 6-24.
When the specified CTG ID is used by
the other program product, use the
other CTG ID which is not used by the
other program product in the storage
system.
When the number of the consistency
groups exceeds the maximum number,
execute one of the following actions:
• To create the TC, UR, GAD or SI
pair after reducing the consistency
groups:
1. Select consistency group which
can be deleted in the existing
consistency groups.
2. Find the configuration definition
file in which the name of the
consistency group to be deleted is
written at dev_group.
3. Execute the pairsplit -S
command specifying the dev_group
name of the consistency group to
be deleted by the HORCM instance
which matches the configuration
217
Troubleshooting
9-13
Command Control Interface User and Reference Guide