Hitachi VSP F1500 - Page 515

raidcom initialize pool
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
Get Command
Status
Async 2E10 6024 The specified pool is being deleted.
Get Command
Status
Async 2E11 0204 The deduplication system data volume defined in
the specified pool or the volume for which the
deduplication function is enabled is not blocked.
CMDRJE Executing 2E11 9400 The command cannot be accepted. Wait a while
and issue the same command.
CMDRJE
Get Command
Status
Executing /
Async
2E20 6000 The specified pool is not installed.
Get Command
Status
Async 2E21 8101 The control memory or shared memory for
Dynamic Provisioning is not installed.
Get Command
Status
Async 2E30 000F The volume defined in specified pool is used as a
journal volume.
CMDRJE Executing 2EE7 00F0 The specified command cannot be accepted
because the command is not supported.
CMDRJE
Get Command
Status
Executing /
Async
2EE7 FEEC The internal error occurs. Contact Hitachi Data
Systems customer support.
Table 9-156 SSB codes returned by raidcom add parity_grp
raidcom add parity_grp
Error message
Executing/
Async
Error code
Description
SSB1 SSB2
CMDRJE
Get Command
Status
Executing/
Async
2E00 000D The emulation type is incorrect.
CMDRJE
Get Command
Status
Executing/
Async
2E00 0101 The parity group number is not in the effective
range.
CMDRJE
Get Command
Status
Executing/
Async
2E00 0108 The RAID type of the specified parity group is not
correct.
CMDRJE
Get Command
Status
Executing/
Async
2E00 7000 The specified CLPR ID is out of the range.
CMDRJE Executing 2E00 8500 The specified drive box or drive is not correct.
Troubleshooting
9-191
Command Control Interface User and Reference Guide