Hitachi WJ Series

Chapter 9 Inverter Functions
9-2-12
9.2.7 Setting Frequency Command by Communication Option Board
 How to set the frequency command using a communication option board?
 To set the output frequency command using a communication option board, set the "Frequency
input source selection [A001]
*1
" parameter to "Option (04)".
 For details regarding setting frequency command from a communication option board, refer
to the instruction manual or user's guide for each option. For each guide, please contact the
supplier where this device was purchased or local Hitachi inverter sales office.
Code
Item
Description
Data
[A001]
*1
Frequency input
source selection
Sets the output frequency command using a communication
option board.
04
*1. "2nd-motor control [SET]" target parameter. The second control parameter is also subject to setting.
Q
A