Hitachi WJ Series

Chapter 10 Monitor Functions
10-3-5
10.3.5 Monitor the Frequency Command Source and RUN Command Source
 How to check if RUN command source is wrong with what was set?
 How to check if the frequency command source is wrong with what was set?
Frequency input source monitor [d062]
 Displays the currently enabled frequency command source.
 The frequency command source varies depending on the status of the input terminal function
and other functions as well as the setting of "frequency reference selection [A001]
*1
". For details,
refer to "9.2 Selecting Frequency Command".
Code
Item
Description
Data
[d062]
Frequency input source
monitor
Keypad (Multi-speed 0)
00
Multi-speed 1 to 15
01 to 15
Jogging
16
Modbus communication
18
Option
19
External POT
21
Pulse input
22
Calculation function result
23
EzSQ
24
[Ai1] terminal (analog voltage) input
25
[Ai2] terminal (analog current) input
26
[Ai1] terminal input + [Ai2] terminal input
27
RUN command input source monitor [d063]
 Displays the currently enabled RUN command source.
 The RUN command source varies depending on the status of the input terminal function and
other functions as well as the setting of "RUN command input source selection [A002]
*1
". Refer
to "9.1 Selecting RUN Command and Alarm Reset" for more information.
Code
Item
Description
Data
[d063]
RUN command input
source monitor
Control terminal
01
Keypad (RUN-key)
02
Modbus communication
03
Option
04
*1. "2nd-motor control [SET]" target parameter. The second control parameter is also subject to setting.
Q
A
!
A
!