Hitachi WJ Series - Page 493

Appendix
A-4-4
P
P24 terminal .................................................................. 5-4-1
P24S terminal ................................................................ 5-4-1
Password function ........................................................ 7-2-6
PCLR .......................................................................... 9-14-10
Peripheral device .......................................................... 5-3-1
Permanent magnet motor (PMM) ............................ 8-1-15
PID .................................................................................. 9-8-1
PID control .................................................................... 9-8-1
PID deviation monitor ............................................... 10-4-1
PID feedback monitor ............................................... 10-4-1
PID output monitor.................................................... 10-4-1
PIDC ............................................................................... 9-8-2
PLA/PLB .......................................................... 5-4-1, 9-5-14
PLC terminal .................................................................. 5-4-1
POK.............................................................................. 9-14-2
POT ................................................................................. 9-2-3
Power LED [PWR] .......................................................... 7-1-1
PRG .............................................................................. 12-2-2
ProDriveNext .............................................................. 12-1-1
Program counter ........................................................ 10-4-1
Program LED [PRG] ....................................................... 7-1-1
Program No. monitor ................................................. 10-4-1
PSET .......................................................................... 9-14-10
PTC .............................................................................. 9-10-7
Pulse input (EzSQ) ..................................................... 12-2-3
Pulse input (frequency reference) ........................... 9-2-13
Pulse input (positioning) ........................................... 9-14-1
Pulse input monitor ................................................... 10-2-2
Pulse output ............................................................... 9-16-5
PWM output ............................................................... 9-16-5
R
Reduced torque (electronic thermal) ........................ 8-1-9
Reduced torque (V/f control) ..................................... 9-5-1
Reduced voltage start .................................................. 9-7-1
REF.................................................................................. 9-1-2
Regenerative braking unit ........................................... 5-3-7
Remote control function ........................................... 9-2-18
Remote operator ............................................ 3-2-5, 7-2-11
REN ................................................................................. 9-4-4
Reset ............................................................................... 9-1-9
Residual risk checklist .................................................. 6-2-1
Restart after free run stop ............................................ 9-7-9
Restart after power-on ................................................. 9-7-8
Restart after trip reset .................................................. 9-7-8
Reverse rotation restriction ......................................... 9-4-3
Reverse rotation signal.............................................. 9-12-2
Reverse U-curve ............................................................ 9-3-5
RJ45 connector ............................................................. 7-1-1
RNT .............................................................................. 9-11-9
Rotation direction monitor ....................................... 10-1-2
RS ........................................................................ 9-1-9, 9-7-8
RS-485 ........................................................................ 11-1-1
RUN ............................................................................. 9-12-1
RUN command active ............................................... 9-12-3
RUN command indicator LED ..................................... 7-1-1
RUN command input source ....................................... 9-1-1
RUN direction restriction ............................................. 9-4-2
RUN key ......................................................................... 7-1-1
RUN-key command rotation direction ....................... 9-1-2
Running LED [RUN] ...................................................... 7-1-1
Running signal ............................................................ 9-12-1
RV.................................................................................... 9-1-3
RVR .............................................................................. 9-12-2