Honeywell Dolphin 75e - To Power a Terminal and Charge Its Main Battery

10 - 5
To Power a Terminal and Charge its Main Battery
1. Install the main battery in the terminal; see Install the Battery on page 1-1.
2. Mount the Mobile base and install the power cable; see Mounting the Mobile Base on page 10-3.
3. Pull the spring latch back and insert the Dolphin 75e into the terminal well. Charging begins immediately if required by
the Dolphin terminal.
Note: Align the contacts on the back panel of the terminal with the charging contacts on the Mobile Base.
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in damage
not covered by the warranty.
!
!