9 - 4
USB Port
This USB port is USB v2.0 Hi-Speed (480 Mbps) compliant. Using a USB cable, you can connect the base to a host device,
such as a workstation (PC). When the terminal is seated in the terminal well, it is connected to the host device via the base.
RJ45 Ethernet Port
Use a standard CAT-5 Ethernet cable; you can connect the ebase to an Ethernet-compliant device to facilitate Ethernet
communication to and from the terminal. The RJ45 connector includes integrated LEDs that provide Ethernet
communication status and speed information.
DC Power Jack
This connector receives input from the power adapter. Plug the power connector cable from the power adapter into this
connector, see Power.
Bottom Panel
For details on how to mount the eBase, see Mounting the eBase on page 9-7.
Power
The base requires 12 Volts DC input for communications, battery charging, and power output to the terminal; the power adapter
included with the base converts the voltage from the AC power source to
12 Volts DC. Use only a UL listed power supply, which has been qualified by Honeywell with output rated at 12VDC and
3 amps with the device. The operating temperature range is -10° to 50°C (14° to 122°F). Honeywell recommends that you
leave the eBase connected to its power source at all times, so that it is always ready to use.
Status Yellow LED Green LED
No Ethernet Link Off Off
10Mbps Ethernet Connection Established Off On
100Mbps Ethernet Connection Established On On
Data transfer in progress Connection Speed Dependent
(see above)
Flashing
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Compliance Label
Serial Number Label
MAC Address Label
To Next Page
Loading...
