Honeywell Dolphin 75e - Configuring the Scan Demo Application

3 - 4
2. Swipe left or touch Settings, and then select Scan.
3. Change the Scan Mode to Continuous.
4. Press the Back button to return to the Scan screen.
5. Press and hold the Scan button to activate the imaging engine. The imager scans and decodes bar codes pre-
sented in the terminal’s field of view as long as the button is pressed. You can also press and hold either the left or
right side buttons to activate the imaging engine.
6. Release the Scan button to deactivate the imager.
To disable the feature set the Scan mode back to Normal.
Configuring the Scan Demo Application
1. Open the Scan Demo .
2. Swipe left or touch Settings.
3. Select Scan, Symbology, or Profiles.
4. Modify the settings to meet your application needs, and then press the Back button to return to the Scan Demo
screen.
Scan Settings
Symbology Settings
The Symbology Settings defines the bar code symbology types the scanner will decode when using the Scan Demo
app. Touch the toggle box next to a symbology to enable or disable the symbology for scanning. Swipe
up or down to scroll through the list of available symbologies.
Profiles
The built-in Point of Service (POS) profiles are applied by the Scan Demo app using the Microsoft POS application
program interface (API) ClaimedBarcodeScanner.SetActiveProfileAsync, which sets the active profile on the terminal
bar code scanner. The profile strings defined by the HoneywellDecoderSetttingsV2.exm file are returned to the app
using BarcodeScanner.GetSupportedProfiles, which gets the list of profiles supported by the bar code scanner.
Setting Description Default Value
Vibrate
When On , the terminal vibrates to indicate a good read. Off
Sound
When On , the terminal beeps to indicate a good read. On
Scan Mode Three scan mode options are available:
• Normal (see Using the Scan Demo to Decode a Bar Code on page 3-2)
• Automatic (see Automatic Scanning on page 3-3)
• Continuous (see Continuous Scanning)
Normal
Automatic Interval Sets the number of seconds between scan attempts. An slider adjustment
allows you to choose between 0 and 30 seconds.
5 seconds
Profile Description
HON:Reset Resets all symbology settings to disabled.
HON:EnablePreviewOnDecode Profile not supported in Scan Demo.
HON:EnablePreviewOnDecodeAttempt Profile not supported in Scan Demo.
HON:DisablePreview Disables sending images to the application. This is the default profile.
Only decode results are shown on the screen.