6 - 7
Installing a Certificate via MDM
Administrators can use MDM software to add root and CA certificates or configure the terminal to enroll a client certificate
with an enrollment server that supports Simple Certificate Enrollment Protocol (SCEP) used for certificate based client
authentication (e.g., Wi-Fi, VPN, email). To learn how to install certificates via MDM, go to “Installing digital certificates” on
the Microsoft Developer Network (MSDN) Web site at https://msdn.microsoft.com/en-us/library/dn643705.aspx.
Removing Certificates
A Factory Reset (Clean Boot) is required to remove a certificate installed on the terminal. To learn how to perform a Factory
Reset, see Resetting the Terminal on page 1-13.
Ethernet Communication
See Establishing Ethernet Communication on page 9-6.
Viewing Network Adapter Information and Renewing/Releasing IP Addresses
The IPConfig app displays, releases, and renews IP parameters for on-board network adapters.
1. In the Apps list, touch IPConfig .
2. From the AdapterInfo screen, touch the box under Adapter.
3. Select one of the integrated network adapters installed in the terminal from the drop down menu:
• Bluetooth Device (Personal Area Network Adapter)
• Qualcomm Atheros Wireless LAN Adapter
• Microsoft Wi-Fi Direct Virtual Adapter
Every field on the screen pertains to the adapter selected from the drop down menu. Swipe up or down to view the
following:
• Mac and IP addresses
•Netmask
• Gateway
• DHCP enabled (Yes or No)
• DHCP server
• Index
• Lease Expiration date
• Lease Obtained date
• Type (e.g. 802.11 or Ethernet CSMACD)
Swipe left to view the NetworkParams screen. This screen provides information on:
•Host Name
• DNS
• Node Type
• Routing enabled (Yes or No)
• Proxy enabled (Yes or No)
To Renew or Release the IP Address used by the selected adapter:
4. Touch more on the AdapterIndfo screen.
5. Select either RenewIPAddress or ReleaseIPAddress.
You can refresh the information shown by selecting .
To Next Page
Loading...
