51
GasAlertMaxXT II
Bump and Calibration Results
Bump and Calibration Results
The detector records the bump test and calibration results. The results
can then be imported into Fleet Manager II to create detailed reports.
The following information is recorded in the Bump/Calibration datalogs:
• Date/time bump tests and calibrations were performed
• Serial number of the detector
• Test performed
•Test results
• Detector user
• Supervisor
• Detector status
• Detector configuration updated during bump test/calibration
• Type of detector
• Location detector was used
• MicroDock II serial number
• MicroDock II location
• Last calibration performed
• Next calibration due date
• Last bump test performed
• Next bump test due date
• Datalog interval
• STEL period
• Pump enabled/disabled
• Audible and visual indicator status
• Sensor type and sensor status
• Alarm status
• Sensor status
• Inlet(s) used
• Definables (employee information)
Downloading Datalogs and Event Logs
The datalog and event log files can only be downloaded to a PC using
the IR Link or the MicroDock II Base Station. Refer to the Fleet Manager
II Operator’s Manual.
Software Requirements
Fleet Manager II and Excel software are required to create spreadsheet
reports of the event logs, datalogs, and bump and calibration results.
To Next Page
Loading...
Need help?
General
