20
Installation and Setup
Mounting the Camera
Preparing the Mounting Surface
1. Affix the mounting template (see Appendix A) to the mounting surface as shown in
Figure 2-1.
2. Pre-drill three holes as indicated on the template, using the recommended hole size
for the screws being used.
3. Drill out conduit hole, if required (see Installing the Conduit Plug, page 22).
Figure 2-1 Mounting Template Guide
Note Alternate fasteners (preferably stainless steel) can be used, provided they are
not larger than the screw holes on the mounting template.
To Next Page
Loading...
