Honeywell HD4DIP - Removing the Gimbal; Figure 2-2 Mounting Holes and Removed Gimbal

HD4DIP Network Camera V2.1 Reference Guide
Document 800-04191 Rev A 21
06/09
Removing the Gimbal
To gain better access to the mounting holes and the wiring board, remove the gimbal from
the enclosure base.
1. Squeeze the 4 black tabs until they are free of the black clips.
2. Elevate the hinge until the gimbal is above the housing and you have access to the
camera board connections and mounting holes.
Figure 2-2 Mounting Holes and Removed Gimbal
Black tabs (x4)
Black clips (x4)
Metal
hinge
Mounting
holes