Document 800-04191 Rev A 31
06/09
3
Installing the Honeywell IP Utility and
Web-Client Software
The Honeywell IP Utility is used to provide the network connectivity for the network
camera system. The IP Utility automatically discovers Honeywell IP devices on the
network and enables you to configure the device settings. Using the IP Utility, you can
configure the IP network settings, name the cameras, upgrade the firmware on the
cameras, and change the user passwords of the device.
Note Before installing and using the Honeywell IP Utility, confirm that your
HD4DIP(X) Network Camera is connected to the network through an Ethernet
cable (see Connecting to a Network via CAT5 Ethernet Connector on page
26).
This chapter covers:
• About the Honeywell IP Utility and Web-Client
• Administrator and Guest user profiles
• Confirming your system requirements
• Installing the Honeywell IP Utility software
• Logging onto the IP Utility and discovering network devices
• Connecting to a device and configuring network settings
• Launching the Web-Client to view live video
To Next Page
Loading...
