Honeywell HD4DIP - Figure 2-4 Camera and Cables; Figure 2-5 Wiring Connection Shown on Board

24
Installation and Setup
Figure 2-4 Camera and Cables
Figure 2-5 Wiring Connection Shown on Board
Caution For secure installations, surface mounted cables should be protected
by plastic or metal cable covers.
Caution Installation must be performed by a qualified electrician. The power
wire size for the distance and the number of cameras must be
determined to maintain 24 VAC or 12 VDC at each camera.
Caution Connect power either from a 24 VAC/12 VDC source or a CAT5
Ethernet connector (PoE); never both at the same time.
24 VAC/12 VDC power
Spot monitor
(see Connecting to a Video Monitor,
page 25)
CAT5 Ethernet connection via network
(see Connecting to a Network via CAT5 Ethernet
Connector, page 26)
Also for Power over Ethernet (PoE 802.3 af)
Spot Monitor Output
and Video Test Output
Audio: Input / Output
Alarm: Input / Output
(see Connecting Alarms, page 26)
RJ45 Ethernet Connector
(see Connecting to a Network via
CAT5 Ethernet Connector, page 26)
Power - +
Reset button