Honeywell HD4DIP - Confirming Your System Requirements

HD4DIP Network Camera V2.1 Reference Guide
Document 800-04191 Rev A 33
06/09
After the IP Utility and Web-Client software is installed, you can change the Administrator or
Guest passwords. Table 3-1 describes the roles and privileges for these users:
Confirming Your System Requirements
Note Windows administrator privileges are required to install the Honeywell IP
Utility and associated software.
Note Contact the network administrator if there are any questions regarding the
local area network (LAN) or any other network related issues.
Install the Honeywell IP Utility on a work station with the minimum requirements in
Table 3-2. After the IP Utility is installed, the same computer work station can be used to
access the Web-Client.
Table 3-1 IP Utility User Roles and Privileges
User Role Privileges
Administrator • View the list of devices available on the network
• Connect to the HD4DIP devices
• Configure the IP network settings
• Upgrade the firmware version
• Change the password for the Web-Client applications
• Change the password for the IP Utility application
• Only 1 Administrator can be logged on at a time
• Can enable/disable a device’s Web-Client
Guest Operator • View the list of devices available on the network and
their system settings
Table 3-2 PC Minimum System Requirements
Component Requirement
Operating System Windows XP® or WINServer 2003
Processor Intel
®
Pentium
®
IV, 2.4 GHz or faster
RAM 512 MB or higher
Web Browser Microsoft® Internet Explorer®, V6.0 or later