52
Before You Begin Configuring
IP and Firmware Settings
The IP and Firmware Settings panel on the Device Settings tab mirrors the information that
is available in the Honeywell IP Utility. It provides read-only network and firmware settings
and video formats without having to access the IP Utility.
Figure 4-5 IP and Firmware Settings on the Device Settings Tab
Alarm Settings
Figure 4-6 shows the alarm settings on the Device Settings tab. See Programming Alarm
Contacts, page 55 for more detailed information.
Figure 4-6 Alarm Settings on the Device Settings Tab
Compression Settings Tab
The video signal sent to the Web-Client from the camera has a number of settings that can
be edited which affect the video as it’s displayed in the Web-Client. The Compression
Settings view enables you to configure these settings.
Device Name as entered in the IP Utility
IP Address on the network (DHCP/Static/APIPA)
Subnet Mask and Default Gateway
address that connects the camera
to the network
MAC Address is a factory assigned
address unique for each device
Firmware Settings including
product name and version
Video Format - NTSC or PAL
Set the Alarm Input as Normally Open,
Normally Close, or Disable
Set the Alarm Output as Normally Open,
or Normally Close
To Next Page
Loading...
