22
Installation and Setup
Installing the Conduit Plug
Your HD4DIP(X) camera enclosure comes with a conduit plug pre-installed in the 3/4 inch
conduit entry on the back. This plug may be removed and installed in the side 3/4 inch
conduit entry (see Figure 2-3).
Figure 2-3 Conduit Plug Installation
WARNING! To minimize moisture leaking into the camera housing,
position the enclosure with the conduit pointing down. After
feeding the cables through (see Wiring, page 23), apply an
appropriate sealant around the conduit connection.
Using the Grommet
If a conduit is not used for cable routing, install the rubber grommet in the conduit hole, then
slit the grommet and feed the cables through (see Wiring, page 23). Seal the grommet to
prevent moisture from entering the housing.
Mounting the Camera
Mount the camera to a wall or ceiling using the supplied screws (see Preparing the
Mounting Surface on page 20).
Conduit plug
Back entry conduit
Side entry conduit
To Next Page
Loading...
