Document 800-04191 Rev A 45
06/09
4
Before You Begin Configuring
Complete the following sections before configuring your HD4DIP(X) Network Camera:
• Chapter 2, Installing the camera and setting it up in a network system
• Chapter 3, Installing the Honeywell IP Utility and Web-Client software
This chapter covers:
• Navigating the Web-Client interface and using the controls
• Understanding the Web-Client features and functions
• Configuring compression settings
• Configuring camera settings
• Setting tamper detection
Logging On and Off the HD4DIP IP Web-Client
Note Only one Administrator user and four Guest users can log on to the
Web-Client application at one time.
There are two ways to open each HD4DIP IP Web-Client:
•By clicking Launch Browser from the IP Utility interface.
• Directly from Internet Explorer by entering the URL (the IP address) in the Address
bar.
Note The web page where you log on to the Honeywell IP Utility and any IP device
web page (for example, the HD4DIP IP Web-Client) look very similar. You can
tell the difference between the two sites by the IP address in the web browser
as well as the program name in the lower left corner of the window.
To Next Page
Loading...
