NVR Configurations | 117
800-18160 - B - 07/2014
HDD Group: The SN of the HDD Group management. See Configuring HDD Group
Settings on page 115.
Note Ensure that you have set the HDD Group for each channel. If you fail to set the
HDD Group for a channel, then you will not be able to save the current setup.
Note When you change the HDD Group settings, the system will save the recorded
video and snapshots, then reboot.
TIPS! There is an easy way to test whether or not the recordings from the corresponding channel are
saved in the specified HDD. Remove the HDD and then check to see if the channel can record.
The channel should not record, and you should not be able to search the previous recordings.
Configuring Abnormality Settings
Click ABNORMALITY in the ADVANCED configuration interface. The ABNORMALITY
configuration interface appears.
To Next Page
Loading...
Need help?
General