NVR Configurations | 119
800-18160 - B - 07/2014
Configuring Alarm Output
1. Click ALARM OUTPUT in the ADVANCED configuration interface. The ALARM OUTPUT
configuration interface appears.
Figure 3-63 ALARM OUTPUT Configuration Interface
2. Click to make your selections, and then click OK to save the changes.
Configuring Manual Recording Settings
Note You must have proper rights to configure the Recording settings. Also, ensure
that the HDD has been properly installed.
1. Click RECORD in the ADVANCED configuration interface.
OR
Right-click the mouse to open the shortcut menu, then click Record.
The RECORD configuration interface appears.
Figure 3-64 RECORD Configuration Interface
2. Select a recording status for each channel, and then click OK to save the changes.
To Next Page
Loading...
Need help?
General