Web Operation | 173
800-18160 - B - 07/2014
Click Multicast in the Network configuration interface to open the Multicast configuration
interface.
Figure 5-38 Multicast Configuration Interface
Configuring Auto Registration Settings
Auto Register allows the device to automatically register to the proxy you have specified. This
allows you to use the client-end to access the NVR through the proxy. The proxy acts as a
switch. In network service, the device supports IPv4 server addresses or domains.
Click Auto Register in the Network configuration interface to open the Auto Register
configuration interface.
Figure 5-39 Auto Register Configuration Interface
Configuring Events
Click the Event arrow to expand the Event selection tree.
To Next Page
Loading...