Web Operation | 185
800-18160 - B - 07/2014
Configuring Storage
Click the Storage arrow to expand the Storage selection tree.
Configuring Schedules for Storage
You can add or remove schedules for recording.
There are four recording modes: General (auto), Motion Detect, Alarm, and MD&Alarm.
1. Click Schedule in the Storage selection tree to open the Schedule configuration
interface.
Show Message Click to enable a pop-up message on your local host PC
screen to let you know an alarm has occurred.
Alarm Upload The system can upload the alarm signal to the center
(including the alarm center).
Send Email The system can send an email when an alarm is detected.
When you have enabled the Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu
SettingNetworkEmail to configure the email
settings. See Configuring Email Settings on page 168.
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.
Table 5-20 Configuring for Abnormalities
Configuration Description
To Next Page
Loading...