www.honeywell.com/security
94 | Performance Series Network Video Recorder User Guide
Note You must click Save after configuring the settings to save them.
How to Record
1. In the Record interface, set the alarm record mode to Schedule.
Go to Main Menu Advanced Record.
Note If you select Manual recording, that mode has the highest priority. So the system
will record all the time instead of because of an alarm trigger.
2. Set the recording type, corresponding channel, week, and date.
• Go to Main Menu
SettingSchedule.
• For the recording type, select from Regular, MD, Alarm, MD&Alarm.
Note You can not select MD&Alarm and MD (or Alarm) at the same time.
3. Set the alarm record and encoder parameters.
• Go to Main Menu
SettingEncode.
4. Set the alarm input as the local alarm, and then select the recording channel. The NVR will
record this channel when an alarm is detected.
Note The system begins the alarm-triggered recording instead of motion
detection-triggered recording if the local alarm and the motion detection event
occur at the same time.
Tour Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. Go toConfiguring Display Settings
on page 106 for tour interval setup.
Note Tours setup here have higher priority than tours setup
in the Display interface. If there is no alarm, the system
implements the tour setup in the Display interface.
Snapshot Click to enable the Snapshot function. A snapshot will be
taken when an alarm occurs.
Buzzer Click to enable the Buzzer function. The buzzer beeps when
an alarm occurs.
Table 3-22 Alarm Configurations
Parameter Description
To Next Page
Loading...