Honeywell HN35160200 - Configuring Live View Settings; Live View; Figure 118 Network Packet Capture Interface

Honeywell 35 Series Network Video Recorder User Guide
91
Note: If the NVR is plugged with the USB disk, click the network packet capture
and set the relevant parameters of the packet capture. The captured data
can be downloaded and used for device problem analysis.
1. Go to Main Menu > Information > Maintenance > Network Packet
Capture.
2. Click Network Packet Capture to enter.
Figure 118 Network Packet Capture interface
3. Choose the USB path to save the file.
4. Set the port, IP, number of packets captured. The default settings are
All, you can choose custom to set.
5. Click START to capture. Click STOP to end capturing. You can
analysis the file.
Configuring Live View Settings
After you logged in, the system goes to main menu, click Live view. You can
view the monitor video of each channel.
The displayed window amount may vary. The actual product shall prevail.
Live View
On the live view interface, you can view the monitor video of each channel.
The corresponding channel displays date, time, and channel name after
you overlay the corresponding information. Refer to the following table for
detailed information.