Honeywell 35 Series Network Video Recorder User Guide
4
No. Name Description
3 HDD
The green light is flash when the device is
recording, if the disk is not working, light is always
bright. The light is off without disk.
Figure 2 Rear Panel (HN350401xx)
Table 3 NVR Rear Panel Description (HN350401xx)
No. Name Description
1
PoE port
Built-in switch. Support PoE function.
For PoE series product, you can use this port to provide
power to the network camera.
2 Network port
10M/100Mbps self-adaptive Ethernet port. Connect to
the network cable.
3 AUDIO OUT
Audio output port. It is to output the analog audio signal
to the devices such as the sound box.
•
Bidirectional talk output.
•
Audio output on 1-window video monitor.
Audio output on 1-window video playback.
4 VGA
VGA video output port. Output analog video signal. It can
connect to the monitor to view analog video.
5 HDMI
High definition audio and video signal output port. It
transmits uncompressed high definition video and
multiple-channel data to the HDMI port of the display
device. HDMI version is 1.4.
6 USB port USB port. Connect to mouse, USB storage device and etc.
7 ALARM I/O
They receive signals from external alarm source. C is COM
port. There is one channel of alarm in; there are four
channels of alarm out.
•
When your alarm input device is using external
power, make sure the device and the NVR have the
same GND.
8 Power switch
Power on/off button.
To Next Page
Loading...