Honeywell HN35160200 - Network; Figure 76 Networks - IP; Table 23 IP Parameters

Honeywell 35 Series Network Video Recorder User Guide
62
Network
IP
User can input the IP address in browser address bar, so that you can
remote access the NVR through Web page.
1. Go to Main Menu > Networks > Networks > IP.
The Network interface is displayed.
Figure 76 Networks - IP
2. Enable DHCP and the router can distribute the IP automatically.
Disable DHCP, you can modify the parameters manually.
3. Set parameters.
Table 23 IP Parameters
Parameter Description
DHCP
Enable the DHCP function. The IP address, subnet mask
and default gateway are not available for configuration
once DHCP is enabled.
•
If DHCP is effective, the obtained information will
display in the IP Address box, Subnet Mask box
and Default Gateway box.
•
If you want to manually configure the IP
information, disable the DHCP function first.
If PPPoE connection is successful, the IP address,
subnet mask, default gateway, and DHCP are not
available for configuration.
IP Address
Enter the IP address and configure the corresponding
subnet mask and default gateway.
IP address and default gateway must be in the same
network segment.
Subnet Mask
Default
Gateway
Obtain DNS
automatically
Enable the function to get the DNS address
automatically.