Honeywell 35 Series Network Video Recorder User Guide
43
Figure 51 Disk Detection Interface
2. Choose Disk that you want to detect. Select All or Key area. Detecting
All needs some time because it detects carefully and
comprehensively; Detecting key section may need a few minutes.
3. Click SCAN.
The system starts detecting the HDD and displays the detection
information.
The green block means good, the red block means bad, if the red
blocks are too much or at key section, please change the disk
immediately
Please turn off the video recording before the disk is detected,
otherwise the recording of video maybe lost.
When the system is detecting HDD, click CANCEL to stop current
detection. When pop-up window shows “Would you like to stop disk
detection?”, click OK to end detecting.
Disk Calculation
Record estimate function can calculate how long you can record video
according to the HDD capacity, and calculate the required HDD capacity
according to the record period.
1. Go to Main Menu > Storage > Disk Calculation.
The Disk Calculation interface is displayed.
To Next Page
Loading...