Installation
Rev 3.01 6 Document 900.0258
10/05
Figure 2-1 DVR Rear Panel (16-Channel Shown)
Setting Unit for NTSC or PAL
Figure 2-2 NTSC/PAL Switch
You can use your DVR with either NTSC or PAL equipment. Before turning on the DVR,
set the switch to NTSC or PAL to match your equipment.
Note You cannot mix NTSC and PAL equipment. For example, you
cannot use a PAL camera and an NTSC monitor.
Caution If you set the switch from NTSC (PAL) to PAL (NTSC), please do
the Factory Reset and Clear All Data. If not, it causes the DVR to
perform wrong operations.
NP
To Next Page
Loading...
