Honeywell HRHD4+ - Alarm in Event Action (Notify) Setup Screen; Figure 3-33 Alarm in Event Action (Notify) Setup Screen

Configuration
Rev 3.01 52 Document 900.0258
10/05
Alarm In Event Action (Notify) Setup Screen
Use this screen to set the DVR to notify the remote site when certain events are
activated.
Figure 3-33 Alarm In Event Action (Notify) Setup Screen
1. Highlight the Sched box and then press # . A schedule screen displays. Set the
schedule as described earlier.
2. Highlight the Notify box and then press # . This toggles between On and Off.
When it is On, the DVR notifies the remote site when certain events occur based
on a defined schedule.
Note For the Notify action to work, the DVR should be registered in the
RAS (Remote Administration System).