Configuration
Rev 3.01 60 Document 900.0258
10/05
camera displayed full screen while displaying the cameo window as a PIP
(picture-in-picture), or displaying the cameras in a grid pattern with the bottom right
window as the cameo.
Note Sequence cannot be used in the 4x4 display mode of the
16-channel, 3x3 mode of the 9-channel, or the 2x2 mode of the
4-channel DVR.
3. Highlight the box beside Event Monitoring and then press # to toggle between
On and Off. When it is On, the video of the lowest camera number among
cameras associated with the event-detected sensor will be displayed in full-screen
on the main monitor during the preset dwell time.
4. Highlight the box beside Event Monitoring Dwell Time and then press # . You
can adjust the event monitoring dwell time from 3 to 60 seconds.
Spot Monitoring Setup Screen
Use this screen (MENU ➤ Display ➤ Spot Monitoring) to adjust the display dwell
time for each camera displayed on the spot monitor. You can also turn event monitoring
on and off.
Figure 3-42 Spot Monitoring Setup Screen
1. Highlight the box beside Sequence Dwell Time and then press # . You can adjust
the sequence dwell time from 3 to 60 seconds.
2. Highlight the box beside Event Monitoring and then press # to toggle between
On and Off. When it is On, the video of the lowest camera number among
cameras associated with the event-detected sensor will be displayed in full-screen
on the spot monitor during the preset dwell time.
3. Highlight the box beside Event Monitoring Dwell Time and then press # . You
can adjust the event monitoring dwell time from 3 to 60 seconds.
To Next Page
Loading...
