Configuration
Rev 3.01 63 Document 900.0258
10/05
LAN Setup Screen
Use the LAN Setup screen (MENU ➤ Network ➤ Network Setup ➤ LAN) to
configure your Local Area Network.
Figure 3-44 LAN Setup Screen
1. Highlight the box beside Type and then press # to select from Manual, DHCP, or
ADSL (PPPoE).
LAN Setup - Manual
Selecting Manual allows you to set up LAN parameters manually.
Note Obtain the appropriate IP Address, Gateway, and Subnet Mask,
from your network administrator.
2. Change the numbers by highlighting them and using the Up and Down Arrow
buttons or the Jog Dial to increase or decrease the number.
The factory default LAN settings are:
3. Highlight the box beside DNS Server and then press # to enter the IP address of
the DNS server. If you set up the DNS Server, the domain name of the DVRNS
server can be used instead of the IP address during the DVRNS Server setup (see
DVRNS (DVR Name Service) Setup Screen, page 68 for more details).
4. Highlight the box beside Port Number … and then press # . The Port Numer
Setup screen displays.
IP Address 192.168.1.129
Gateway 192.168.1.254
Subnet Mask 255.255.255.0
To Next Page
Loading...
