Configuration
Rev 3.01 61 Document 900.0258
10/05
Network Setup Screen
Use the Network Setup screen (MENU ➤ Network ➤ Network Setup) to set up the
DVR for LAN connections.
Figure 3-43 Network Setup Screen
1. Highlight the box beside Connection. Press # to toggle between LAN and
Modem.
2. Highlight the box beside Admin Password and then press # . A virtual keyboard
displays (see Figure 3-7). You will first be asked to enter the current password.
Then you can enter a new password; you will be asked to confirm the new
password before it is accepted.
3. Highlight the box beside User Password and then press # . A virtual keyboard
displays. You will first be asked to enter the current password. Then you can enter
a new password; you will be asked to confirm the new password before it is
accepted.
Note These passwords are for network use. They are different
from the Admin and User passwords for the DVR itself.
The passwords are case sensitive. The factory default
password for both Administrator and User is 12345678.
Caution Write the password down and keep it in a safe place. After the
password has been reset, the default will no longer work. If the
password is forgotten, the unit must be reset using the Factory
Reset Button and all data settings will be lost.
To Next Page
Loading...
