Configuration
Rev 3.01 70 Document 900.0258
10/05
Callback Center Setup Screen
You can set up the DVR to contact a computer running RAS (Remote Administration
System) and send an E-mail on a LAN when an event occurs. You can also set it up to
dial a pager with a numeric message when an event occurs if you have a modem
connected to the DVR.
Callback Center Setup by LAN Connections
Access the Callback Center Setup screen (MENU ➤ Network ➤ Callback Center).
Figure 3-50 Callback Center (LAN) Setup Screen
1. Highlight the box beside IP Address and enter the IP address of the computer
you want contacted during an event.
2. Highlight the box beside Retry and enter the number of times you would like the
DVR to try contacting the computer. You can select from 1 to 10 retries.
3. Highlight the box beside E-mail notification and then press # to toggle between
On and Off.
4. Highlight the box beside SMTP Server IP and enter the SMTP server IP address,
obtained from your system administrator.
5. Highlight the box beside E-mail recipient and enter the recipient's e-mail address.
Use the virtual keyboard (see Figure 3-7) to enter the e-mail address.
6. Highlight the box beside E-mail sender and enter the sender's e-mail address.
Note The e-mail address must include the character @ to be a valid
address.
To Next Page
Loading...
Need help?
General