Installation
Rev 3.01 15 Document 900.0258
10/05
Factory Reset
Figure 2-15 Factory Reset Switch
The DVR has a Factory Reset switch to the right of the USB port. This switch will only
be used on the rare occasions that you want to return all the settings to the original
factory settings.
Caution When using the Factory Reset, you will lose any settings you have
made. If you wish to use the same DVR name registered on the
DVRNS server (see DVRNS (DVR Name Service) Setup Screen,
page 68) after initializing the system using the factory reset, you
need to contact the DVRNS server manager. Please record and
save the help desk information before performing a factory reset.
To reset the unit, you need a straightened paper clip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, poke a straightened paper clip in the unlabeled hole
to the right of the USB port.
4. Hold the switch until all the LEDs on the front panel are lit.
Note When the DVR successfully resets to factory defaults all the LEDs
on the front panel flash three times.
5. Release the reset switch. All of the DVR settings are now at the original settings it
had when it left the factory.
USB
Factory reset
switch
To Next Page
Loading...
