Honeywell HRHD4+ - Figure 3-35 Motion Detector Event Action (Alarm Out) Setup Screen; Motion Detector Event Action (Alarm Out) Setup Screen

Configuration
Rev 3.01 54 Document 900.0258
10/05
Motion Detector Event Action (Alarm Out) Setup Screen
Use this screen to set the DVR to react to motion events differently by activating an
internal buzzer or external alarms.
Figure 3-35 Motion Detector Event Action (Alarm Out) Setup Screen
1. Highlight the Sched box and then press # . A schedule screen displays. Set the
schedule as described earlier.
2. Highlight the Alarm Out box and select Beep and/or the alarm output terminal
that you want to associate with the motion event.
3. Highlight the Dwell Time box and set the length of time you want the output
activated.
Note When setting the dwell time to 0 sec, the alarm output will be
activated throughout the sensor activation period, and inactive
while the sensor is inactive.