Honeywell MS9540 - RSS Bar Code Implementation; Enable RSS 14 Bar Code

19
RSS BAR CODE IMPLEMENTATION
Metrologic’s MS9520 Voyager
®
and MS9540 VoyagerCG
®
laser scanners with
software #14810 and higher can be configured to scan RSS type codes.
XT keyboard will no longer be supported in standard software releases
with software #14810 or higher. If XT keyboard is needed for your
application, software #14806 or lower is required, contact a Metrologic
customer service representative at 1-800-ID-METRO for further
assistance.
³100011
Double Border Required - When scanning RSS
bar codes, it is recommended that double border
requirements be enabled because of the large
spaces often found in RSS symbologies.
³100413
Enable RSS 14
³100403
* Disable RSS 14
³114900
* Transmit RSS 14 Check Digit
³114910
Do Not Transmit RSS 14 Check Digit
³114901
* Transmit RSS 14 Application ID - Application
Identifier “01” is transmitted by default.
³114911
Do Not Transmit RSS 14 Application ID
³114902
* Transmit RSS 14 Symbology ID - Symbology
Identifier “]e0” is transmitted by default.
³114912
Do Not Transmit RSS 14 Symbology