66
MS9520/9540-00 LASER EMULATION MODE
ENABLE HANDHELD LASER EMULATION MODE
The MS9520-00 and MS9540-00 leave the factory with Laser Emulation interface
enabled.
If you recall defaults while re-configuring your scanner, scan the following
barcode to re-enable the Laser Emulation interface. The scanner you are using
must be labeled as an MS9520-00 or MS9540-00 to support this feature.
Enable HH Laser Emulation
³999979
If host controlled laser emulation is required scan the following bar code after
scanning the Enable HH Laser Emulation bar code.
Enable Host Controlled Laser Emulation
³117010
³117001
Normal Laser Emulation Motor Idle State
³117011
Reverse Laser Emulation Motor Idle State
To Next Page
Loading...
