83
MS9535 VOYAGERBT
®
When the MS9535 acts as a client to other Bluetooth devices that have a
Bluetooth address that is NOT headed with FNC3 but is just a common 12-digit
hex value (e.g. 000CA700118), scan the Get Bluetooth Address code first, then
scan the devices address bar code.
Get Bluetooth Address
³ 000CA7FFFFFF
Scan the Provide Service bar code to place the MS9535 into service mode. In this
mode, other Bluetooth-enabled devices can initiate a connection to the scanner.
Provide Bluetooth Service
³000CA7000000
³124316
Bluetooth PIN Required – the MS9535 will require
a valid Bluetooth PIN when Bluetooth-enabled
devices try to initiate a communication connection.
³124306
* Bluetooth Pin Not Required
³840900
Bluetooth PIN Default Value – the default PIN ID
will be the last 4 digits of the serial number
³999918
Next Bar Code is Bluetooth Pin – when scanned
this feature enables the scanner to store the next
scanned bar code as the Bluetooth PIN ID. The
Bluetooth PIN ID must be numeric and be 4 to 16
characters in length.
The Bluetooth PIN Required bar code (shown
above) must also be scanned to utilize the PIN ID.
³998045
Enable Bluetooth Address Transmission
³998044
Enable Bluetooth Software Version Transmission
³819560
Sleep in 1 Minute - The scanner will go into sleep
(power save) mode after the laser has been off for
1 minute.
³8195120
Sleep in 2 Minutes - The scanner will go into sleep
mode after the laser has been off for 2 minutes.
To Next Page
Loading...
