68
USB
³4155114
Enable USB Interface
♦
³999978
Enable Low Speed USB Defaults
♦
♦ This feature is limited to Metrologic scanners without integrated Low Speed USB
electronics. These bar codes configure the scanner to communicate via the MX009.
³999940
Load Integrated Full Speed USB Keyboard
Emulation Defaults
³999970
Load Integrated Full Speed USB IBM/OEM
Defaults
³999931
Load Integrated Low Speed USB OPOS Defaults
–
limited to scanners with internal Low- Speed USB
interfaces with specific software versions.
³316430
IBM OEM Scanner 4B00h Handheld – Full Speed
USB Only
³3164010
IBM OEM Scanner 4A00h Flatbed – Full Speed
USB Only
³316400
* Enable USB Keyboard Emulation Mode
³316470
Enable Uni-Directional USB Serial Emulation Mode
Enables Uni-Directional USB Serial Emulation Mode
in Metrologic 9500/5100/4125 class products.
Enables Bi-Directional USB Serial Emulation Mode
in the Metrologic Focus/Imager class products.
³316460
Enable Bi-Directional USB Serial Emulation Mode
Enables Bi-Directional USB Serial Emulation Mode
in Metrologic 9500, 5100, and 4125 class products.
Not supported for Focus/Imager class products.
If the Recall Defaults bar code is scanned while reconfiguring the scanner, the
scanner configuration will revert to the default setting, USB Keyboard Emulation
Mode. Rescan the Bi-Directional or Uni-Directional USB Serial Emulation Mode
bar code to enable the appropriate Serial Emulation Mode.
To Next Page
Loading...
