35
SCANNER OPERATION
HOST SCANNER COMMANDS
³141715
Use Protocol Prefix and Suffix for Bar Code
Transmission
³141705
* No Protocol Prefix and Suffix for Bar Code
Transmission
³119917
Enable RTS on No Read – After a NOREAD
occurs, the scanner will activate the RTS line for 20
milliseconds. The duration of the RTS activation
can be loaded in address 199 bits 6 - 0 in 10
millisecond steps.
³119907
* Disable RTS on No Read
TEST MODES
³118017
Scanability ON - This option enters scanability test
mode. Do not enable unless instructed by a
Metrologic representative.
³118007
* Scanability OFF
³118016
Scan Count Mode ON - The scanner will enter
scan count test mode and the scanner’s firmware
number will transmit to the host. Do not enable
unless instructed by a Metrologic representative.
³118006
* Scan Count Mode OFF
³115512
Power-Up with Saved Interface - Do not enable
unless instructed by a Metrologic representative.
³115502
* Power-Up with Board Interface - Do not enable
unless instructed by a Metrologic representative.
To Next Page
Loading...
