28
SCANNER OPERATION
SAME SYMBOL TIME OUTS
The length of time before a bar code can be rescanned after it is removed from
the scan field is user-configurable in increments of 50 msecs to 6350 msecs
(6.35 sec).
If using an MS9500 or IS4125, please go to page 80.
³918900
~ Variable Same Symbol Time Out - In configuration
mode, scan this bar code followed by the appropriate
code byte sequence (on page 70) to set the same
symbol time out duration. This feature is not
supported for the MS9500 or IS4125, refer to
page 80 for additional information.
³818900
No Same Symbol Time Out
³118917
Infinite Same Symbol Time Out - The scanner will
not repetitively scan the same bar code. This
option overrides the symbol rescan time-outs.
³119414
Enable 2 Second Time Out - after 2 seconds of
inactivity the laser will turn off and stay off until the
CodeGate button is pressed. This feature is for the
MS5145 only.
³119404
Disable 2 Second Time Out
LED OPTIONS
³118313
Flash Green LED if Rescan Allowed - This
indicates same symbol timeout has elapsed.
³118303
* Do Not Flash Green LED if Rescan Allowed
³118312
Reverse LED Functions - Red = Laser On
Green = Good Read
³118302
* Normal LED Functions - Green = Laser On
Red = Good Read
To Next Page
Loading...
