Honeywell MX9 - Page 307

Parameter Default Function
Cisco IE = Cisco Information Element.
WMM Off
Use of Wi-Fi Multimedia extensions.
Options are: On, Off
Auth
Server
Type 1
Specifies the type of authentication server.
Options are: Type 1 (ACS server) and Type 2 (non-ACS server)
TTLS Inner
Method
Auto-EAP
Authentication method used within the secure tunnel created by EAP-TTLS.
Options are:
AUTO-EAP (Any available EAPmethod)
MSCHAPV2
MSCHAP
PAP
CHAP
EAP-MSCHAPV2
PMK
Caching
Standard
Type of Pairwise Master Key (PMK)caching to use when WPA2 is in use. PMK caching is designed
to speed up roaming between APs by allowing the client and the AP to cache the results of 802.1X
authentications, eliminating the need to communicate with the ACS server. Standard PMK is used
when there are no controllers. The re-authentication information is cached on the original AP. The
client and the AP use the cached information to perform the four-way handshake to exchange keys.
Opportunistic PMK(OPMK) is used when there are controllers. The re-authentication information
cached on the controllers. The client and the controller behind the AP use the cached information to
perform the four-way handshake to exchange keys.
If the selected PMK caching method is not supported by the network infrastructure, every roam
requires full 802.11X authentication, including interaction with the ACS server.
If the active profile is using WPA2 CCKM, the global PMKCaching setting is ignored and the client
attempts to use CCKM.
Options are: Standard, OPMK
Note: This change does not take effect until after a Suspend/Resume cycle.
WAPI Off Default is Off and dimmed (cannot be changed).
TX
Diversity
BG: On
A: Main
Only
How to handle antenna diversity when transmitting packets to the Access Point.
Options are: Main only (use the main antenna only), Aux only (use the auxiliary antenna only), or On
(use diversity or both antennas).
RX
Diversity
BG: On-
Start on
Main
A: Main
Only
How to handle antenna diversity when receiving packets from the Access Point.
Options are: Main Only (use the main antenna only), Aux Only (use the auxiliary antenna only), On-
start on Main (on startup, use the main antenna), or On-start on Aux (on startup, use the auxiliary
antenna).
9-19