NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14 111
How to Manually Initialize a Detector Detector Initialization
E.4 How to Manually Initialize a Detector
You only need to manually initialize a detector when you change a detector during Walk Test or
Advanced Walk Test. If, however, you replace a detector with a different type of detector, you must
immediately program the new detector according to the instructions in “How to Replace a
Detector” on page 110.
To manually initialize a detector, follow these steps:
1. Press the
ENTER key. The control panel displays the Program Entry screen:
2. Press the 1 key. The control panel displays the Enter Password screen:
3. Enter the password
RESET, which starts detector initialization. The control panel displays the
following three screens, in the sequence shown, while initializing a detector:
When the control panel completes the detector initialization, it displays system status as shown
below:
1=PROGRAMMING 2=READ STATUS ENTRY
(ESCAPE TO ABORT)
ENTER PROG OR STAT PASSWORD, THEN ENTER.
(ESCAPE TO ABORT)
Detector Initializing _ Please Wait
02:48P 041508 Tue
CHECKING MEMORY NFS2-640 Release 1.0
Software #XXXXXXX
SYSTEM NORMAL 02:50P 041508 Tue
To Next Page
Loading...
