Honeywell Spyder 5

SPYDER MODEL 5 ENGINEERING TOOL – USER GUIDE
29 31-00282ES-01
5. If desired, you can enter the device ID, Network address, and MAC Address.
6. Enable Use Cov by selecting ´true` from the drop-down List box.
7. Click OK.
RESULT: The devices are matched as the properties of the disconnected offline IRM BACnet device indicate in the
Database pane. The device gets the data of:
• Device ID
• Status
e.g. Alarm, unacknowledged alarm.
• Model
• Firmware Revision
• Serial No.
• Irm Family
• Irm Program Name
• Irm Application Type
• Irm Sync Status
synchronized or not synchronized
• Irm Last Change
• Irm Master Sync
The Irm Sync Status shows whether the device is part of a master sync group (source, target, none)
The application status is checked by learning the project from the controller as displayed in the following message: